Care & Cleaning Guide

For Best Results, Less is Best

Clean the bathing area with a soft cloth, sponge (safe for Teflon surface) or soft brush and warm water. To soften mineral deposits, use a solution of vinegar and water. REMEMBER: Always thoroughly rinse your bath or shower system with warm water after cleaning.

Do not use your new bath or shower for at least 24 hours after installation or use recommended cleaning products for at least one week after installation. Do not ever use abrasive cleansers, such as Soft Scrub, Comet Scratch Free, cleaning powder or scouring pads. To test for abrasive agents, rub a small amount between your fingers… if it is rough, it will scratch your acrylic system. Do not use any products with Ammonia-D or acetone (nail polish remover), any products using an aerosol propellant, products with harsh chemicals such as Lysol Disinfectant, Dow Disinfectant and Lestoil, crystal drain cleanser or any leave on cleansers.

Most store-bought, non-abrasive and non-aerosol bathroom cleansers are safe to use, such as Glass Plus, 409, Fantastik, Kaboom and Scrub Free.